Knowledge

How to solve the problem that the spray drying equipment trips immediately after startup.

In food production, the drying process is often involved, and the spray dryer plays an important role in the food drying process. With the rapid development of food drying industry, there are vacuum, microwave, spray, rotary flash dryer and other drying equipment on the market. Next, let's take a look at the principle of the spray dryer and what problems should be paid attention to in application. This spray drying equipment is a kind of equipment that can complete drying and granulation. Generally speaking, it can change the material from liquid state to atomized state. The feed liquid is sprayed into very fine atomized liquid beads through the atomizer at the top of the tower body, so as to touch with hot air and dry into finished products in a very short time. The spray dryer is suitable for drying some heat sensitive liquids, suspensions and viscous liquids, such as milk, eggs, etc. The spray dryer is hygroscopic. The parts of the cyclone separator, its pipes and the pollinator shall be wrapped with thermal insulation materials, so as to avoid moisture absorption of the dried products. During preheating, the atomizer shall be placed at the top of the drying room, and the drying room and the feeding opening of the cyclone separator shall be sealed to prevent cool air from entering the drying room and reduce the preheating efficiency, Improper cleaning and maintenance of the nozzle may cause residual substances in the spray plate or the main shaft to be twisted and deformed.

The current situation is generally related to the electric control system. If it is the case that the power supply air switch is too small, or the spray dryer may have been burned in a short circuit. The above conditions can be checked and recognized separately. Whether the air compressor is burned can be recognized by checking the three-phase resistance and grounding resistance with a multimeter. If the machine still has no response after pressing the button, first observe whether the alarm indicator light on the panel of the spray dryer is on. If the high-pressure alarm light is on, you must find the high-voltage protection switch. There is a green reset button on the protection switch. Press it once to reset and start. If the overload indicator light is on, you can find the thermal overload relay in the electrical junction box and press the red button on it.

If the alarm has been solved and the spray dryer still can not operate normally, then confirm the incoming power supply, confirm whether the red indicator light of the shutdown power supply is on, and check whether the two-phase or three-phase power supply voltage is normal and whether there is phase loss. When the spray dryer starts spray, the flow shall be small and gradually increased until appropriate; Check whether the pipeline is blocked, adjust the solid content of the material, and ensure the fluidity of the material liquid. The material liquid is spray into very fine mist like liquid beads through the centrifugal atomizer or high-pressure atomizer on the top of the tower. It can be dried into finished products in a short time when it flows in parallel with the air. It has excellent dispersibility, fluidity and solubility; The production process is simplified and the operation is convenient.

https://www.tydryers.com/

You Might Also Like

Send Inquiry