Knowledge

Do you know some precautions when using spray dryer

The spray dryer is mainly applicable to the spray drying of suspended liquids, high viscosity materials or solid content liquids. It is widely used in food and chemical industries. It has the characteristics of fast drying speed, simple operation and one-time drying into powder particles. In the application process, some operation methods are required to avoid problems caused by operation errors.

1. if the sugar content of the material is high, it is not suitable for spray, because the sugar will stick in the cavity and cause ablation.

2. check the fan speed and butterfly valve orientation. In addition, check whether the pipes of filters, heaters, etc. are blocked, whether the connecting parts are firmly connected, how airtight they are, and whether the pressure is within the specified range.

3. before each application, the two oil filling ports of the atomizer must be filled with oil.

4. in the process of closed operation, when spraying organic solvents (such as ethanol, xylene, etc.), the oxygen concentration must be controlled below 5% (the oxygen concentration can reach the required value by re introducing N2 or restarting the machine), otherwise the organic solvents have the risk of incineration and explosion.

5. when replacing spray materials every time, the pipes, cyclone separators, atomizers and collectors shall be cleaned and dried to avoid affecting the quality of materials. For the atomizer, check whether the lubricating oil height is in the normal direction of the vernier ruler line (mainly: the oil filling should not exceed the oil level line, otherwise the oil will penetrate into the lower part of the main shaft until the atomization disk leaks). After startup, check whether the oil supply of the main oil pump is normal. If the oil pump fails to supply oil, shut down immediately, disassemble and repair the oil pump or exchange it. It can be used only after the oil supply is normal. During operation, the operator shall check and pay attention to the oil supply of the oil pump at any time;

6. during the operation of the spray dryer, do not touch the rotating parts (atomizer, atomizing disc, belt and motor fan blade). In order to extend the service life, it is recommended to use the rotation method of two atomizers during practical operation. Generally, the atomizer needs to remove the atomization plate, material liquid distribution plate, guide shaft and other parts for cleaning after continuous operation for a period of time. If the guide bearing is slightly scratched, it can be polished with fine abrasive cloth. If there is severe scratch, replace the bearing. When the continuous operation time is long, the water tank can be equipped for cooling to properly extend the service life;

7. the surface temperature of the spray dryer is relatively high during operation or after shutdown. Please do not touch the bag filter, cyclone separator, air duct, atomizer, exhaust fan, observation window and other components with your hands. Compressed air is selected as the power source for the atomizer, and the working pressure limit shall be 0.4-0.5 MPa. The working air source shall be dry and clean. The user shall configure the air source filter pressure reducing valve in the air source and atomizer center.

8. when the temperature of the drying tower does not drop to normal temperature, please do not enter the tower.

9. if the water content of the product is large, it means that the exhaust temperature is too low or the feeding is too fast. At this time, the feeding amount should be appropriately reduced to improve the exhaust temperature.

https://www.tydryers.com/

You Might Also Like

Send Inquiry